Home › Battery Technology › Murata launches MGJ2T2 isolated DC-DC converters for SiC gate drives in EV charging
Battery Technology

Murata launches MGJ2T2 isolated DC-DC converters for SiC gate drives in EV charging

calendar_today
schedule 2 min read
A modern electric SUV parked in a serene forest, blending nature and technology.

Summary

Murata has introduced the MGJ2T2 series of 2 W isolated DC-DC converters designed to drive silicon carbide MOSFET gates in high-voltage applications such as EV charging and energy storage. The converters offer reinforced insulation up to 800 Vrms and high common-mode transient immunity for reliable operation across isolation barriers.

Murata Manufacturing has introduced the MGJ2T2 series of 2 W isolated DC-DC converters for silicon carbide (SiC) MOSFET gate drivers in high-voltage applications including energy storage and distribution, motor drives and EV charging.

The converters operate from a 24 V input and provide +18 V/-3 V bipolar outputs. The positive rail provides the voltage required to turn the power device on, and the negative rail supports turn-off.

Fast switching in SiC-based power converters produces rapid voltage changes that can couple electrical noise across the isolation barrier between the power stage and its control circuitry. The MGJ2T2’s 2.5 pF isolation capacitance limits this coupling. Its common-mode transient immunity (CMTI) of more than 200 kV/μs enables the converter to tolerate rapid common-mode voltage transitions.

The MGJ2T2 uses Murata’s proprietary Block-Coil technology. Separate windings are formed on solid insulating formers, providing physical separation between the primary and secondary circuits while reducing the capacitance between them. The construction provides more than 8 mm of creepage and clearance. Murata says the solid insulation barrier also provides high partial-discharge tolerance.

The series supports reinforced insulation at working voltages up to 800 Vrms, or basic insulation up to 1,600 Vrms, and is tested to withstand 6 kV DC across the isolation barrier. It is designed to meet IEC 60664-1. These characteristics allow the gate-drive supply to operate where the control electronics and SiC power stage are at different voltage potentials.

Murata says the same characteristics are relevant to solid-state transformer (SST) architectures, which use high-frequency power conversion and can divide high input voltages across multiple cascaded switching stages. Each switching element requires an isolated gate-drive power supply.

The MGJ2T2 series operates over a temperature range of -40° C to +125° C and is supplied in a single in-line package (SIP).

Source: Murata

Share this article

The Green Wire Weekly

Weekly deep dive into sustainable transport.

Comments

No approved comments yet. Be the first to comment.

Leave A Reply

Comments are temporarily unavailable.

Related Coverage